We are running an iMX7s processor with Linux on the A-core and MQX on the M-core. The M-core is booted first and sets up the GPIO it needs and begins running. The A-core finishes booting Linux at a later point in time and we have found that the GPIO driver associated with imx35-gpio (found in the imx7s.dtsi) is completely re-initializing all GPIO ports, 'stomping' on the settings the M-core/MQX had established.
The driver is gpio-mxc.c on the Linux side, and the probe function, static int mxc_gpio_probe(struct platform_device *pdev) is clearing the entire port's IMR register among other things. From our debug output it appears that probe is called for each port listed in the dtsi, essentially clearing all gpio port settings and then setting up the individual pins called out in the DTS. This behavior seems OK if the A-core is the only core in operation, but this is not acceptable with the M-core already up and running. It seems that the driver should read/modify/write the port registers based on which pins are actually called out in the systems' DTS. Having the A-core boot first, then launching the M-core may mitigate this, but having the M-core up first is one of the 'selling' points of this processor.
I have tried resetting the M4 core after Linux has completed booting; this allows MQX to re-initialize all its own GPIO and associated interrupts, but the failure still occurs. Linux is responding to the interrupts and clearing the masks. The interrupts we are trying to use on the M-core are GPIO1 0-7. Each has its own interrupt vector. I have also tried installing a 'dummy' ISR for the group GPIO 0-15 interrupt, thinking that Linux was possibly still responding to this and inadvertently clearing the IMR, but no luck. Even after the M-core reboots and MQX reloads, the ISRs only fire in Linux, presumably handled by the default handlers, as we are not installing any interrupts on GPIO1 on the Linux side. I'm beginning to suspect that it may be a priority issue between the A-cores GIC and the M-cores NVIC?
Are we missing something or is this expected behavior?